[Mar-2022] Free 200-301 Exam Questions 200-301 Actual Free Exam Questions [Q33-Q58]

[Mar-2022] Free 200-301 Exam Questions 200-301 Actual Free Exam Questions

Verified 200-301 dumps and 216 unique questions

How to book the 200-301 CCNA Exam: Cisco Certified Network Associate

You can schedule the exam anytime at Cisco/certifications. You can pay directly from a credit card or redeem a voucher purchased from.

NEW QUESTION 33
Refer to the exhibit. Which Command do you enter so that R1 advertises the loopback0 interface to the BGP Peers?

A. Network 172.16.1.32 0.0.0.31
B. Network 172.16.1.33 mask 255.255.255.224
C. Network 172.16.1.32 255.255.255.224
D. Network 172.16.1.0 0.0.0.255
E. Network 172.16.1.32 mask 0.0.0.31
F. Network 172.16.1.32 mask 255.255.255.224

Answer: F

NEW QUESTION 34

Refer to the exhibit. An engineer is configuring the New York router to reach the Lo1 interface of the Atlanta router using interface Se0/0/0 as the primary path. Which two commands must be configured on the New York router so that it reaches the Lo1 interface of the Atlanta router via Washington when the link between New York and Atlanta goes down? (Choose two.)

A. Ipv6 route 2000::1/128 2012::1
B. Ipv6 route 2000::1/128 2012::1 5
C. Ipv6 route 2000::1/128 2012::2
D. Ipv6 route 2000::1/128 2023::3 5
E. Ipv6 route 2000::1/128 2023::2 5

Answer: A,D

Explanation:
Section: IP Connectivity
Explanation:
Floating static routes are static routes that have an administrative distance greater than the administrative distance (AD) of another static route or dynamic routes. By default a static route has an AD of 1 then floating static route must have the AD greater than 1. Floating static route has a manually configured administrative distance greater than that of the primary route and therefore would not be in the routing table until the primary route fails.

NEW QUESTION 35
Drag and drop the Cisco Wireless LAN Controller security settings from the left onto the correct security mechanism categories on the right.

Answer:

Explanation:

NEW QUESTION 36
Which command must you enter to enable OSPFV2 in an IPV4 network?

A. ip ospf hello-interval seconds
B. router ospf value
C. router ospf process-id
D. router ospfv2 process-id

Answer: C

NEW QUESTION 37
A frame that enters a switch fails the Frame Check Sequence. Which two interface counters are incremented?
(Choose two)

A. frame
B. input errors
C. CRC
D. runts
E. giants

Answer: B,C

Explanation:
Explanation
Whenever the physical transmission has problems, the receiving device might receive a frame whose bits have changed values. These frames do not pass the error detection logic as implemented in the FCS field in the Ethernet trailer. The receiving device discards the frame and counts it as some kind of input error.
Cisco switches list this error as a CRC error. Cyclic redundancy check (CRC) is a term related to how the FCS math detects an error.
The "input errors" includes runts, giants, no buffer, CRC, frame, overrun, and ignored counts.
The output below show the interface counters with the "show interface s0/0/0" command:

NEW QUESTION 38
What is the function of a hub-and-spoke WAN topology?

A. supports application optimization
B. supports Layer 2 VPNs
C. allows access restrictions to be implemented between subscriber sites.
D. provides direct connections between subscribers

Answer: D

NEW QUESTION 39
Refer to the exhibit.

If the network environment is operating normally, which type of device must be connected to interface FastEthernet 0/1?

A. PC
B. router
C. DHCP client
D. access point

Answer: C

NEW QUESTION 40
When a switch receives a frame for a known destination MAC address, how is the frame handed?

A. flooded to all ports except the one from which it originated
B. sent to the port identified for the known MAC address
C. broadcast to all ports
D. forwarded to the first available port

Answer: D

NEW QUESTION 41
Drag and drop to the characteristics of networking from the left onto the correct networking types on the right.

Answer:

Explanation:

NEW QUESTION 42
An email user has been lured into clicking a link in an email sent by their company's security organization. The webpage that opens reports that it was safe but the link could have contained malicious code. Which type of security program is in place?

A. brute force attack
B. Social engineering attack
C. Physical access control
D. user awareness

Answer: D

Explanation:
This is a training program which simulates an attack, not a real attack (as it says "The webpage that opens reports that it was safe") so we believed it should be called a "user awareness" program. Therefore the best answer here should be "user awareness". This is the definition of
"User awareness" from CCNA 200- 301 Offical Cert Guide Book:
"User awareness: All users should be made aware of the need for data confidentiality to protect corporate information, as well as their own credentials and personal information. They should also be made aware of potential threats, schemes to mislead, and proper procedures to report security incidents. " Note: Physical access control means infrastructure locations, such as network closets and data centers, should remain securely locked.

NEW QUESTION 43
What is the purpose of traffic shaping?

A. to provide fair queuing for buffered flows
B. to mitigate delays over slow links
C. to limit the bandwidth that a flow can use to
D. be a marking mechanism that identifies different flows
Traffic shaping retains excess packets in a queue and then schedules the excess for later transmission over increments of time.

Answer: A

NEW QUESTION 44
Refer to Exhibit.

Which action do the switches take on the trunk link?

A. The trunk forms but the mismatched native VLANs are merged into a single broadcast domain.
B. The trunk does not form, but VLAN 99 and VLAN 999 are allowed to traverse the link.
C. The trunk does not form and the ports go into an err-disabled status.
D. The trunk forms but VLAN 99 and VLAN 999 are in a shutdown state.

Answer: B

NEW QUESTION 45
A network engineer is configuring an OSPFv2 neighbor adjacency Drag and drop the parameters from the left onto their required categories on the right. Not all parameters are used

Answer:

Explanation:

NEW QUESTION 46
Which type of wireless encryption is used for WPA2 in pre-shared key mode?

A. TKIP with RC4
B. AES-128
C. RC4
D. AES-256

Answer: D

Explanation:
We can see in this picture we have to type 64 hexadecimal characters (256 bit) for the WPA2 passphrase so we can deduce the encryption is AES-256, not AES-128.

Reference: https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/67134-wpa2-config.html

NEW QUESTION 47
Refer to the exhibit.

which path is used by the router for internet traffic ?

A. 209.165.200.0/27
B. 10.10.10.0/28
C. 0.0.0.0/0
D. 10.10.13.0/24

Answer: C

NEW QUESTION 48
Drag and Drop Question
Drag and drop the network protocols from the left onto the correct transport services on the right.
Select and Place:

Answer:

Explanation:

NEW QUESTION 49
An administrator must secure the WLC from receiving spoofed association requests. Which steps must be taken to configure the WLC to restrict the requests and force the user to wait 10 ms to retry an association request?

A. Enable MAC filtering and set the SA Query timeout to 10.
B. Enable 802.1x Layer 2 security and set the Comeback timer to 10.
C. Enable the Protected Management Frame service and set the Comeback timer to 10.
D. Enable Security Association Teardown Protection and set the SA Query timeout to 10.

Answer: D

Explanation:
Section: Network Access

NEW QUESTION 50
Drag and Drop Question
Drag and drop the AAA functions from the left onto the correct AAA services on the right.

Answer:

Explanation:

NEW QUESTION 51
Refer to the exhibit.

A network administrator assumes a task to complete the connectivity between PC A and the File Server.
Switch A and Switch B have been partially configured with VLAN 10, 11, 12, and 13. What is the next step in the configuration?

A. Add PC A to the same subnet as the Fie Server allowing for intra-VLAN communication.
B. Add VLAN 13 to the trunk links on Switch A and Switch B for VLAN propagation
C. Add PC A to VLAN 10 and the File Server to VLAN 11 fa VLAN segmentation
D. Add a router on a stick between Switch A and Switch B allowing for Inter-VLAN routing.

Answer: B

NEW QUESTION 52
Drag and drop the IPv4 network subnets from the left onto the correct usable host ranges on the right

Answer:

Explanation:

NEW QUESTION 53
Refer to the exhibit.

Which change to the configuration on Switch?
allows the two switches to establish an GtherChannel?

A. Change the protocol to EtherChannel mode on.
B. Change the LACP mode to desirable
C. Change the protocol to PAqP and use auto mode
D. Change the LACP mode to active

Answer: D

NEW QUESTION 54
An engineer needs to add an old switch back into a network. To prevent the switch from corrupting the VLAN database which action must be taken?

A. Add the switch with DTP set to desirable
B. Add the switch with DTP set to dynamic desirable
C. Add the switch in the VTP domain with a higher revision number
D. Add the switch in the VTP domain with a lower revision number

Answer: C

NEW QUESTION 55

Refer to the exhibit. The New York router is configured with static routes pointing to the Atlanta and Washington sites.
Which two tasks must be performed so that the Serial0/0/0 interfaces on the Atlanta and Washington routers can reach one another? (Choose two.)

A. Configure the ipv6 route 2023::/126 2012::2 command on the Atlanta router.
B. Configure the ipv6 route 2023::/126 2012::1 command on the Atlanta router.
C. Configure the ipv6 route 2012::/126 s0/0/0 command on the Atlanta router.
D. Configure the ipv6 route 2012::/126 2023::2 command on the Washington router.
E. Configure the ipv6 route 2012::/126 2023::1 command on the Washington router.

Answer: A,D

Explanation:
Section: IP Connectivity

NEW QUESTION 56
Refer to the exhibit.

Router R2 is configured with multiple routes to reach network 10 1.1 0/24 from router R1. What protocol is chosen by router R2 to reach the destination network 10.1 1 0/24?