Ultimate Guide to Prepare Free Cisco 200-301 Exam Questions and Answer

Pass Cisco 200-301 Tests Engine pdf - All Free Dumps

NEW QUESTION 114
DRAG DROP

Answer:

Explanation:

NEW QUESTION 115
Refer to the exhibit.

Shortly after SiteA was connected to SiteB over a new single-mode fiber path users at SiteA report intermittent connectivity issues with applications hosted at SiteB What is the cause of the intermittent connectivity issue?

• A. Interface errors are incrementing
• B. High usage is causing high latency
• C. The sites were connected with the wrong cable type
• D. An incorrect SFP media type was used at SiteA

Answer: B

NEW QUESTION 116
An engineer is configuring NAT to translate the source subnet of 10.10.0.0/24 to any of three addresses
192.168.30.1, 192.168.3.2, 192.168.3.3 Which configuration should be used?

• A. Option C
• B. Option D
• C. Option B
• D. Option A

Answer: A

NEW QUESTION 117
Refer to the exhibit. Which command provides this output?

• A. show cdp neighbor
• B. show ip interface
• C. show ip route
• D. show interface

Answer: A

NEW QUESTION 118
Which function does IP SLA ICMP ECHO operation perform to assist with troubleshooting?

• A. congestion detection
• B. hop-by-hop response time
• C. packet-loss detection
• D. one way jitter measurement E

Answer: B

NEW QUESTION 119
Drag the descriptions of IP protocol transmissions from the left onto the IP traffic types on the right.

Answer:

Explanation:

NEW QUESTION 120
DRAG DROP

Answer:

Explanation:

NEW QUESTION 121
Refer to the exhibit.

Which configuration issue is preventing the OSPF neighbor relationship from being established between the two routers?

• A. R1 has an incorrect network command for interface Gi1/0
• B. R2 should have its network command in area 1
• C. R1 interface Gil/0 has a larger MTU size
• D. R2 is using the passive-interface default command

Answer: C

NEW QUESTION 122
Which technology provides chassis redundancy in a VSS environment?

• A. multichassis EtherChannels
• B. StackWise
• C. VRRP
• D. BFD

Answer: A

NEW QUESTION 123
Refer to the exhibit.

Which command provides this output?

• A. show cdp neighbor
• B. show ip interface
• C. show ip route
• D. show interface

Answer: A

NEW QUESTION 124
Which two protocols are supported on service-port interfaces? (Choose two.)

• A. Telnet
• B. SCP
• C. SSH
• D. RADIUS
• E. TACACS+

Answer: A,C

Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration-guide/b_cg75/b_cg75_chapter_011

NEW QUESTION 125
How to enable vlans automatically across multiple switches?

• A. Configure VTP
• B. Configure each VLAN
• C. Configure VLAN
• D. Confiture NTP

Answer: A

NEW QUESTION 126
Which two WAN architecture options help a business scalability and reliability for the network? (Choose two)

• A. single-homed branches
• B. static routing
• C. dual-homed branches
• D. asychronous routing
• E. dynamic routing

Answer: C,D

NEW QUESTION 127
Drag and drop the AAA functions from the left onto the correct AAA services on the right

Answer:

Explanation:

NEW QUESTION 128
DRAG DROP
A network engineer is configuring an OSPFv2 neighbor adjacency. Drag and drop the parameters from the left onto their required categories on the right. Not all parameters are used.
Select and Place:

Answer:

Explanation:

Section: IP Connectivity

NEW QUESTION 129
Which step in the router boot process searches for an IOS image to load into the router?

• A. POST
• B. bootstrap
• C. ROMMON mode
• D. mini-IOS

Answer: B

NEW QUESTION 130
Refer to the exhibit.

What is the metric of the route to the 192.168.10.33/28 subnet?

• A. 0
• B. 1
• C. 2
• D. 3
• E. 4

Answer: C

NEW QUESTION 131
When implementing a router as a DHCP server, which two features must be configured'? (Choose two)

• A. manual bindings
• B. smart-relay
• C. address pool
• D. relay agent information
• E. database agent

Answer: A,C

NEW QUESTION 132
Refer to the exhibit.

If R1 receives a packet destined to 172.16.1.1, to which IP address does it send the packet?

• A. 192.168.13.3
• B. 192.168.14.4
• C. 192.168.15.5
• D. 192.168.12.2

Answer: B

NEW QUESTION 133

Refer to the exhibit. An engineer is bringing up a new circuit to the MPLS provider on the Gi0/1 interface of Router 1. The new circuit uses eBGP and learns the route to VLAN25 from the BGP path.
What is the expected behavior for the traffic flow for route 10.10.13.0/25?

• A. Traffic to 10.10.13.0/25 is asymmetrical.
• B. Route 10.10.13.0/25 learned via the Gi0/0 interface remains in the routing table.
• C. Route 10.10.13.0/25 is updated in the routing table as being learned from interface Gi0/1.
• D. Traffic to 10.10.13.0/25 is load balanced out of multiple interfaces.

Answer: B

Explanation:
Section: IP Connectivity
Explanation:
The AD of eBGP (20) is smaller than that of OSPF (110) so the route to 10.10.13.0/25 will be updated as being learned from the new BGP path.

NEW QUESTION 134
Router A learns the same route from two different neighbors, one of the neighbor routers is an OSPF neighbor and the other is an EIGRP neighbor. What is the administrative distance of the route that will be installed in the routing table?

• A. 0
• B. 1
• C. 2
• D. 3

Answer: C

Explanation:
Explanation
The Administrative distance (AD) of EIGRP is 90 while the AD of OSPF is 110 so EIGRP route will be chosen to install into the routing table.

NEW QUESTION 135
Which cloud service model does the engineer recommend?

• A. infrastructure-as-a-service
• B. platform-as-a-service
• C. business process as service to support different types of service
• D. software-as-a-service

Answer: D

NEW QUESTION 136
Which option about JSON is true?

• A. used for storing information
• B. similar to HTML, it is more verbose than XML
• C. uses predefined tags or angle brackets () to delimit markup text
• D. used to describe structured data that includes arrays

Answer: D

Explanation:
JSON data is written as name/value pairs.
A name/value pair consists of a field name (in double quotes), followed by a colon, followed by a value:
"name":"Mark"
JSON can use arrays. Array values must be of type string, number, object, array, boolean or null..
For example:
{
"name":"John",
"age":30,
"cars":[ "Ford", "BMW", "Fiat" ]
}

NEW QUESTION 137
Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this router?

• A. 10.154.154.1
• B. 192.168.5.3
• C. 172.16.5.1
• D. 10.1.1.2

Answer: C

Explanation:
The highest IP address of all loopback interfaces will be chosen -> Loopback 0 will be chosen as the router ID.

NEW QUESTION 138
An engineer must configure a WLAN using the strongest encryption type for WPA2-PSK.
Which cipher fulfills the configuration requirement?

• A. AES
• B. WEP
• C. TKIP
• D. RC4

Answer: A

Explanation:
Many routers provide WPA2-PSK (TKIP), WPA2-PSK (AES), and WPA2-PSK (TKIP/AES) as options.
TKIP is actually an older encryption protocol introduced with WPA to replace the very-insecure WEP encryption at the time. TKIP is actually quite similar to WEP encryption. TKIP is no longer considered secure, and is now deprecated. In other words, you shouldn't be using it.
AES is a more secure encryption protocol introduced with WPA2 and it is currently the strongest encryption type for WPA2-PSK/

NEW QUESTION 139
......

Online Exam Practice Tests with detailed explanations!: https://braindumps2go.dumptorrent.com/200-301-braindumps-torrent.html